If you’re looking for instructions on how to install a mini orbis heater, look no further than this article. You can follow along by following the directions provided in the manufacturer’s manual and following local building codes. You can also hire a professional to assist you if you’re unsure of the process. In this article, we’ll provide you with some of the most important tips for getting the job done.
Installation Process
Once the water heater is plugged into the cold water pipe, it’s time to connect the supply lines. Before you begin the installation process, you should disconnect the hot water supply. The hot water pipe must be shut off at the circuit breaker. Make sure you have the right supply line to the water heater. Then, you must remove the hoses that connect to the faucet. Now, you can begin the next step: installing the new valve.
Powered Off
First, you must ensure that your mini orbis heater is powered off. The only way to check whether it’s powered off is to turn off the power supply at the circuit breaker. You can also shut off the cold water supply from your faucet to prevent any damage to the mini water heater. Depending on the model, it may even be possible to plug it into a 120-volt electrical outlet. Some models, however, require electrical upgrades, so check the specifications of your existing unit to determine if it is suitable for your home’s electricity system.
Turn Off the Water Supply
After turning off the electrical supply, you must turn off the hot water pipe. You should then remove the front face plate to access the panels and drain valve. If you’re working with copper pipes, clean them with a sandpaper cloth. You should also dismantle the junction box to access the electrical wiring. After removing the junction box, you should attach the fittings. Once you’ve installed the tank, you need to connect the water line to the tank using the plumbing connection.
Timekeeping and Attendance
If you don’t know how to connect the supply lines, purchase a stainless steel braided supply line from a home improvement center or plumbing supply store. Make sure the length of the supply line is equal to the distance between the cold and hot water inlet on the orbis heater. Then, connect the second stainless steel supply line from the faucet. You can use the same pipe to connect the two components. You can use the same supply line to drain the old one.
Safety of Water Heaters
Once you have the necessary tools for the installation, you must shut off the cold water supply. You must also shut off the cold water supply before attempting to remove the water heater. You should do this by running the hot faucet until it is cold. Afterwards, you should open the cold tap. If you’re planning to move the water heater to another location, you should make sure that you’re using a different one.
Final Words
Before you start installing the mini water heater, you need to ensure that you have the proper plumbing. It is important to choose the right model. The best way to do this is to consider the type of your home and what you need. A flow-through point-of-use model heats a small amount of water continuously, while a storage model will keep a large volume of water warm for a longer period of time.